Valox film on mold

[JD Howard]

We have a couple of molds that use valox material the problem is after the run the valox leaves behind a film in some areas of the mold and its very time consuming to remove we have tried several different heavy duty mold cleaners and so far nothing seems to break it down or at least loosen it up does anyone know of a product that might work.
Thanks

[rickbatey]

I have used two methods to remove this from Valox and POM. Easy Off oven cleaner and Slide's resin remover. The Slide is easier and is to be used on a hot mold while running parts. Open the door, spray, throw the nest few shots away, then keep the rest of them.
Rick.

[JD Howard]

Thanks i didnt even think of easyoff oven cleaner we have used the slide resin remover and it does work ok in the press and hot but not when its on the bench and cold thanks again I will get some oven cleaner for when its on the bench.