How long after the thermoforming process or injection process is the Varnish applied? It sounds like moisture. The molding process will produce a very dry part, while the thermoforming process is a secondary process, so by nature, it will allow the PC to absorb some moisture.
Other that that, I can't think of anything else that might affect it.
Hope that helps!
It is hardly too strong to say that the Constitution was made to guard the people against the dangers of good intentions. There are men in all ages who mean to govern well, but they mean to govern. They promise to be good masters, but they mean to be masters.”
My posts represent my opinion and not those of this site, its ownership, or the company where I am employed.