Deburring Thermal formed Plastic Parts

thermoforming related discussions

Deburring Thermal formed Plastic Parts

Postby rickthompson on Wed Aug 24, 2005 3:17 pm

I have been asked to determine if there is a significant need for deburring edges of certain plastic parts after thermal forming and cutting.

I know it is required in some of the more rigid, higher temperature materials, such as rydel r. Are there other materials which are must be deburred when stricter edge tolerances are required?

Thanks for any feedback.
Posts: 3
Joined: Wed Aug 10, 2005 1:38 pm

Postby Brian Richard on Thu Aug 25, 2005 10:38 am

This would depend on the customer requirements and your trimming method.
Brian Richard
Posts: 752
Joined: Tue Sep 10, 2002 12:00 am
Location: Ontario, New York

Return to Thermoforming

Who is online

Users browsing this forum: No registered users and 0 guests