I'm looking for info on this rotational moulding simulation software.
Thank-you!
-A
RotoSim
3 posts • Page 1 of 1
Re: RotoSim
by krolleken on Sat Oct 22, 2005 7:54 am
- krolleken
- Posts: 1
- Joined: Sat Oct 22, 2005 7:50 am
- Location: Gent
Re: RotoSim
by [email protected] on Fri May 12, 2006 11:43 am
Did you ever have any sucsess in puchasing a rotosim.If so can you forward me details of contact.
Thanks,
Sean
Thanks,
Sean
- [email protected]
- Posts: 1
- Joined: Wed May 05, 2004 7:49 am
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests
©1994 -
All Rights Reserved | www.plastics.com | Site Map Tel: 0.1.978.342.9000 |
Email: