Looking for off-spec PP
Moderator: Skip
3 posts • Page 1 of 1
Looking for off-spec PP
by William5000 on Fri Jan 28, 2005 3:38 pm
Hello. I'm looking for a source for about 10 million lbs annually of off-spec, secondary PP for injection molding. Any leads would be appreciated. Thanks.
- William5000
- Posts: 12
- Joined: Fri Jan 28, 2005 3:32 pm
Re: Teach me
by William5000 on Wed Dec 07, 2005 10:12 am
card56284 @ Wed Dec 07, 2005 5:04 am wrote:William5000 wrote:Hello.
I am you humble slave and would be honoured if you could tell me how you did that?
How I did what?
- William5000
- Posts: 12
- Joined: Fri Jan 28, 2005 3:32 pm
Re: Looking for off-spec PP
by Louis on Wed Dec 07, 2005 10:41 am
Message deleted ~L
Please ignore that deleted post, he was just posting to get his gambling site on-line.
Please ignore that deleted post, he was just posting to get his gambling site on-line.
email: louis AT plastics DOT com.
My posts represent my opinion and not those of this site, its ownership, or the company where I am employed.
My posts represent my opinion and not those of this site, its ownership, or the company where I am employed.
-
Louis - Site Admin
- Posts: 4092
- Joined: Wed Aug 29, 2001 12:00 am
- Location: Allentown, PA USA
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests
©1994 -
All Rights Reserved | www.plastics.com | Site Map Tel: 0.1.978.342.9000 |
Email: